MTL3081 MILLIVOLT ISOLATOR for low-level signals.
The MTL3081 takes the signal from a thermocouple or dc millivolt source in a hazardous area, isolates it, and passes it on to the
receiving instrument in the safe area. It is ideally suited to applications where the thermocouple signal is fed directly into the receiving instrument, rather than converted beforehand into 4/20mA. The safety drive, which is optional, can be enabled by a link to initiate either a high or low output in the event of thermocouple burnout or cable breakage. The direction of the safety drive is set by a switch in the top of the unit. The unit is very easy to use since its ±50mV input range is sufficient to cope with all common thermocouple outputs, and so there are no calibration procedures to worry about. Furthermore, its input terminals are non-energy-storing which allows installation in virtually any IS system without further certification.
MTL3000 series
Product Code Description
MTL3011 Switch/proximity detector relay - volt-free contacts
MTL3012 Switch/proximity detector relay - solid state
MTL3013 Switch/proximity detector relay - 2-channel
MTL3014 Switch/proximity detector relay - dual outputs
MTL3021_22 Solenoid/alarm driver ~ IIC loop powered
MTL3041 Repeater power supply - 4/20mA for 2-wire transmitters
MTL3042 DC isolator - 4/20mA loop powered for I/P converters
MTL3043 DC isolator - 1/40mA for fire and smoke detctors
MTL3045 Isolating driver - 4/20mA for I/P converters
MTL3046B Repeater power supply - for ‘smart’ transmitters
MTL3052 Digital isolator - for signals up to 10kHz
MTL3054 Communications isolator/ repeater
MTL3058_59 Serial data interface ~ RS232 general purpose
MTL3071 Temperature converter ~ THC or emf input
MTL3072 Temperature converter ~ 3-wire RTD input
MTL3073 Temperature converter ~ THC or RTD input
MTL3081 Millivolt isolator - for low-level inputs
MTL3099 Dummy isolator - for terminating and isolating unused cores
MTL3992 High stability power supply